Time 2 Bumper Opinions?

General Discussion
1

I got some Gadgeteer screen protectors and installed one.

Wondering if I should get one of the bumpers people mention once and while?

Suggested sources? ( I can have someone 3D print if that’s the best way to go. )

2

There’s Bumper | Pebble Time 2 case cover - Favourite Human Design by astosia

And https://thangs.com/designer/astosia%20/3d-model/Bumper%20|%20Pebble%20Time%202%20Case-1554295 for printing it yourself

3

Thanks. I’d run across those while looking around. I also see there is a variation on the charging stand I’ve already downloaded a .stl file for that I hadn’t seen yet.

4

I like this model from Jake of All Trades on Printables, though it can pop off if pressed from the bottom a bit (though most bumpers will as far as I can tell)

Requires 3D printing, but uses essentially no filament, so you could have someone print like 20 of them overnight and you’d probably never run out.

PLA or PETG works fine, no major difference in how well it stays on in my experience.